Flyers are notorious for chewing out sutures after any surgery. To save yourself from staying awake 24/7 until recovery, try an E-collar which prevents them from chewing. Keep a close watch one your furball as removing sutures is one of their "Missions".
Here's Kay's Method:
"You can make an Elizabethan collar out of a Dixie cup or a piece of cardboard. Make the hole is JUST big enough to slip over the head because you can't hold them still enough to close it. I use duct tape and make the hole too small, and by trial and error, enlarge it until I can put it over the head and they can't get it off.
Here are instruction from Glider Central:
1.) Trace template onto clear plastic notebook cover, then cut out.
2.) 1 sheet Dr. Scholls molefoam- cut 2 strips ¼” along long edge.
3.) Remove one adhesive strip and stick one on top of another leaving one adhesive strip for later.
4.) Cut ¾” off of dual layer molefoam- remove backing and adhese to clear plastic as shown.
5.) 1 sheet moleskin- sut a strip 1-3/8” wide down length
6.) Cut slits ½” deep at ½ “ intervals down length
7.) Turn collar over molefoam side down. Remove backing from moleskin. Affix uncut edge to collar- about ¼” of it
8.) From the middle of moleskin- wrap around over molefoam, maintaining contours. Trim excess mole from edge.
9.) Cut 1/2” strip from moleskin
10.) Remove backing and adhese over slitted mole skin.
11.) Cut 1 strip 1-3/4” long X 5/8” wide
12.) Remove backing and place on edge of collar
13.) Wrap around edge of collar
14.) The Complicated Collar- Apply a small amount of duct tape, Fold a small amount of duct tape over to make a tab for easy removal.
Tips, experience & advice related to the healthy and not-so-healthy flying squirrel
1 post • Page 1 of 1
- Site Admin
- Posts: 9119
- Joined: Mon Aug 09, 2004 3:30 pm
- nobotspam: No
- How many feet does a squirrel have?: 4
- Location: Fleming Island, FL
"A lot of people spend time talking to the Animals, but not that many people listen. That's the real problem! ... Winnie the Pooh
Who is online
Users browsing this forum: No registered users and 2 guests